Search results

Date Relevance Most replies

  1. N

    Votol EM-100 & EM-150 controllers

    Thanks for your reply, I tried those settings but unfortunately I think the issue is with the controller because it hasn't changed anything. I tried it with another motor and had the exact same issue, although now it appears the problem is getting worse. When it gets to the point of whining, it...
  2. N

    Votol EM-100 & EM-150 controllers

    Just to update on the situation with my Votol EM-150/2, I still haven't got it running right even after tweaking every parameter to recommended settings. I actually can't understand why it's behaving the way it is. It will accelerate normally up to a low speed, after that there will be a whining...
  3. N

    Votol EM-100 & EM-150 controllers

    Well it looks like I have run into another problem with the Votol EM-150-2, I tried messaging Siaecosys but they're not replying anymore. When the motor spins up it will reach a speed limit of around 2k RPM which is really a bit low, it will also cut power under too much throttle input. I...
  4. N

    Votol EM-100 & EM-150 controllers

    So I managed to solve the issue, turns out it's not actually a throttle error but the controller was in park and locking out the throttle itself. I've worked out I can get it to work normally, as long as I short out the park cables momentarily before using the throttle. Does this sound about...
  5. N

    Votol EM-100 & EM-150 controllers

    I'm measuring a range of 0.838v to 4.61v on the throttle signal pin which is within the range specified by the software. Currently it is set to: low protect: 0.34v start voltage: 1.27v end voltage: 4.31v high protect: 4.82v The software doesn't show a throttle output voltage that I can see...
  6. N

    Votol EM-100 & EM-150 controllers

    Hello everyone, I have a Votol 150-2 SP and I've already been on quite a journey trying to get this thing to work. At first it was non-responsive and would not connect to the software via adapter. The controller seemed to be flashing out an error code via the LED. I tried everything including...
  7. N

    Grin Phase Runner / CA3 and BBSHD

    I found this thread while searching for a solution to my Phaserunner MT cutting out connected to a BBSHD. When I connected my controller to the Phaserunner suite, it was reading an "Instantaneous phase overcurrent" fault. I have seen others with the same problem and I've found a solution to it...
Back
Top