Search results

Date Relevance Most replies

  1. B

    CA v3.1 setup not working

    Bike has been running fine. Think ill switch to 700c x 36 or 40 to smooth out the ride at higher speed. It'll cruise with moderate peddle effort at 30mph with 600w. Have ridden 70 miles so far no problem. Back seat added which has been fun as well.
  2. B

    CA v3.1 setup not working

    SOLVED. ended up being the default values of the ebrake which i do not even have. Changed default value from .5v to 0v and wam bam. Thanks for all the help guys
  3. B

    CA v3.1 setup not working

    UPDATE! Got my throttle in the mail and have accurate throttle input voltage of .89 to 4v and associated throttle percentage for given throttle travel, however just as with the kingmeter 24pole PAS the output just stays at .49v no matter the setting. But... connected directly to the...
  4. B

    CA v3.1 setup not working

    Was thinking of this. Just ordered will see what happens.
  5. B

    CA v3.1 setup not working

    Controller powers on has led status indicating working and in sensored mode. It also powers on the cycle analyst which has no errors via its troubleshooting screen . Motor worked fine on old bike but i did brick the controller so maybe that damaged the halls? I think i need to test hall sensors...
  6. B

    CA v3.1 setup not working

    Controller was purchased with the standard 9 pin bafang pinout as the input; plug and play to the motor.
  7. B

    CA v3.1 setup not working

    Motor never worked with this setup. It came from a working igo that I bricked the controller on. The serial is as follows RM G120.250.DC 13 1 007F2U2135003. It has more coiling cycles and the connector type is 007 not 008 like some other bafangs but the connector is the same. Cant find the...
  8. B

    CA v3.1 setup not working

    Bike reads all parameters fine, registers RPM from the PAS, however when the crank is rotated nothing happens. Disclaimer; when I power up the battery/controller, I do get a brief bump from the hub motor. Setup is as follows: UPP 48v 20amp pack Bafang G010 250w motor geared hub (stamped as...
  9. B

    ASI Bacdoor access

    BAC500 trying to configure using an ft232r serial usb. BacDoor v1.5.3 won't let it connect due to checksum error. COM ports and drivers are setup correctly. If anyone has a means of connecting via bluetooth and lives in the San Diego region I'd be gracious if I could use your bacdoor access to...
Back
Top