Search results

Date Relevance Most replies

  1. C

    BBS-FW: Open Source Firmware for BBSHD/BBS02 Controller

    I still have the problem of the system thinking it’s overheating. I watched it today on a five minute ride going uphill, it got up to around 156°F then it started being jerky. As the temperature had started to climb, I reduced the PAS level to where it was putting out a little over 1000 W. While...
  2. C

    BBS-FW: Open Source Firmware for BBSHD/BBS02 Controller

    I have the same problem/request for Daniel. I know that the features working, but it does not cut out long enough. Or just not implemented properly. I think it would be best. If instead of cutting out completely, it cut down to 100 W, for a sufficient period of time, that would be perfect...
  3. C

    BBS-FW: Open Source Firmware for BBSHD/BBS02 Controller

    Hi Daniel, I have the same problem with my bbshd overheating when set to 33A. I just have to run it at full throttle for about 5-10 min before it overheats. When it does, the motor isn’t hot to the touch, just pretty warm. It’ll happen when going up a hill, maxed out at 15mph, and at slower...
  4. C

    BBS-FW: Open Source Firmware for BBSHD/BBS02 Controller

    Daniel’s documentation states his FW file works on both BBS02 & HD. You can set the amps to 33, however it is not recommended.
  5. C

    BBS-FW: Open Source Firmware for BBSHD/BBS02 Controller

    Thank you for following up in the additional information. I replied to you in GitHub, I’m not sure that I fully understand, I mainly want pas to kick in as soon as possible and stop as soon as possible. Regarding the temperature, you are correct, I have configuration in metric, and my display...
  6. C

    BBS-FW: Open Source Firmware for BBSHD/BBS02 Controller

    As another update, I think the gearshift sensor needs to have a greater delay. As someone else had mentioned, I am also noticing more of a clunk when shifting.
  7. C

    BBS-FW: Open Source Firmware for BBSHD/BBS02 Controller

    I'm just running at 30amp, but looks like I need to change temperature sensor to monitor only the controller.
  8. C

    BBS-FW: Open Source Firmware for BBSHD/BBS02 Controller

    As a follow up, my PAS is now working. I set start delay to 75 and increased stop delay to 150. It feels pretty good, I think I would prefer the stop to be quicker, but I can live with that. When PAS wasn't working, I think my stop delay was at 50, so it must need to be higher than that. I can...
  9. C

    BBS-FW: Open Source Firmware for BBSHD/BBS02 Controller

    Hello, thanks for all of your efforts! This is awesome. I donated some money. :) I mainly came across this because I was having issues with my throttle being at 9, when peddling in a lower pas setting, it caused the throttle to be on/off, which was really bad when in pas 1. New install of...
Back
Top