Search results

Date Relevance Most replies

  1. E

    Custom 125 mx conversion

    Ah ....I see thanks, I have a switch for 2 modes, but its wired incorrectly as it's just functioning just as a on off switch.
  2. E

    Custom 125 mx conversion

    Thanks Dom...where do I find the 3 gear setting you have mentioned please.
  3. E

    Custom 125 mx conversion

    Thanks for that. Was looking at changing StartKi and MidKi to 4 and 8 respectively.....as I understand this also has influence on when the torque is in the rev range unless I've got confused!
  4. E

    Custom 125 mx conversion

    59t rear and 10t front.
  5. E

    Custom 125 mx conversion

    Couple pics of bike
  6. E

    Custom 125 mx conversion

    Hi there folks, I have recently acquired a new bike. Could those who know more than me look at the below settings and let me know if they look okay in general. Qs138 90h Fardriver nd72360 72v 70ah battery I would like to move the torque curve up the rpm range a bit as atm just spinning...
  7. E

    Electric Quad Bike Advice

    40 mph top end ....strong acceleration to top end. Run for 2.5 hrs at average of about 20 mph would be good
  8. E

    Electric Quad Bike Advice

    Hi there, I'm happy to sway out the controller I have currently. There's nothing on label apart from 60v 50amp max discharge. Any advice on new controller. Battery wise thinking 72v 35ah / 40ah would be good for the quad...?
  9. E

    Electric Quad Bike Advice

    Any good reputable lipo sellers in the UK that anyone uses ?
  10. E

    Electric Quad Bike Advice

    Hi there PaPaSteve thanks for the reply - I was of the understanding that the motor may well be only 1500w but at 60v the controller can output upto 50 amps so that would be 3000w of power all be it for a short burst. However I agree that the claim of 40mph is stretching it a bit far 😀.
  11. E

    Electric Quad Bike Advice

    Hi amberwolf many thanks for the swift response. Voltage does sag but only a few volts....from 60v to 58v under full throttle with no load and with person on it. I will look into the software you have mentioned to what the settings are running at. Thinking I will be going down the route of...
  12. E

    Electric Quad Bike Advice

    Hi there folks, Looking for some advice please. I have bought an electric quad bike, Dazzle Pro quad 1500w 60v with 60v 20ah lead acid battery made up of 5x12v 20ah packs. It's got a Votol em100 controller rated at 50amp max so prob 25amp constant. Currently only goes 30mph with no load [me...
Back
Top