Andy@MiRider
1 mW
- Joined
- Sep 25, 2019
- Messages
- 14
Morning Guys,
My company sell an ebike with the controller below. The wiring is like a rats nest and far too complicated for me. What is involved in going to Canbus type controller, Is it possible to make or buy adaptors to allow me to connect the canbus controller to my bikes current Non-Canbus loom or will we need to get a canbus specific look manufactured to suit the bike?
Also, thr PAS is set by the manufacturer to of the controller to not activate until the crankset has rotated 300 degrees and this is causing too much of a "Lag" when customers ride the bike. is there any way for me to reduce this lag in PAS engagement please guys?
Chinese wiring diagrams are utter pants...the colour of the wires on the controller and look dont even match.....aaaarrgghhh
My company sell an ebike with the controller below. The wiring is like a rats nest and far too complicated for me. What is involved in going to Canbus type controller, Is it possible to make or buy adaptors to allow me to connect the canbus controller to my bikes current Non-Canbus loom or will we need to get a canbus specific look manufactured to suit the bike?
Also, thr PAS is set by the manufacturer to of the controller to not activate until the crankset has rotated 300 degrees and this is causing too much of a "Lag" when customers ride the bike. is there any way for me to reduce this lag in PAS engagement please guys?
Chinese wiring diagrams are utter pants...the colour of the wires on the controller and look dont even match.....aaaarrgghhh