nethern
1 mW
- Joined
- Feb 3, 2018
- Messages
- 18
I finish riding from work. The juice was almost out. I took It out to meter each cell to see is any one had problem because i realize there had been a sudden power lost during the ride.
I put It on the table, taking multimeter to test the first group cells. I realised the first group that connects the positive output. So, i started with the first group. First one was dead, second one also dead. When i touched the third one, there was a spark. I was surprised a bit, then resumed measureing. I Did not know when i Did wrong when i have one of the probes touch the third cell again, The nickel strip started to turn red. A small flame went off. I quickly took It outside and back to grabed the Fire extinguisher. The Fire was off when i came back. I carefully cut the wire Than is still connect to the group.
i wonder where went wrong?i have tested the cell many times before, no problem. Why This time?
Please help me. I dont want This happen next time
I put It on the table, taking multimeter to test the first group cells. I realised the first group that connects the positive output. So, i started with the first group. First one was dead, second one also dead. When i touched the third one, there was a spark. I was surprised a bit, then resumed measureing. I Did not know when i Did wrong when i have one of the probes touch the third cell again, The nickel strip started to turn red. A small flame went off. I quickly took It outside and back to grabed the Fire extinguisher. The Fire was off when i came back. I carefully cut the wire Than is still connect to the group.
i wonder where went wrong?i have tested the cell many times before, no problem. Why This time?
Please help me. I dont want This happen next time