eflyersteve
10 W
Purchased this controller and I'm finding that the LVC setting to be far from accurate:
https://www.electricrt.com/collections/controllers-1/products/e-r-t-3000w-sinewave-controller
I measure the battery at 47v and with the controller LVC set to 38v the controller won't run the motor. If I lower it to 36 the motor pulses under any load.
Obviously I would want the setting to be somewhat accurate, but 11ish volts seems extreme. Is there a component on board that I can change to get a more accurate voltage reading?
Thanks in advance!
https://www.electricrt.com/collections/controllers-1/products/e-r-t-3000w-sinewave-controller
I measure the battery at 47v and with the controller LVC set to 38v the controller won't run the motor. If I lower it to 36 the motor pulses under any load.
Obviously I would want the setting to be somewhat accurate, but 11ish volts seems extreme. Is there a component on board that I can change to get a more accurate voltage reading?
Thanks in advance!
