Recent content by Tiger_one

Changing to LifeP04 280ah 16s, so most likely will sell the existing powerwall. Most of these batteries came from medical modems which I took apart and built these strings over several months. All batteries were capacity tested and average 2700 ma for the whole pack. I sorted these in groups...

I know I'm late to this party, but. I just purchased one of these BMSs (without their blueTooth module) from Battery Hookup for 16s lifeP04 DIY build. I do Arduino/ESP32 stuff, so have a bluetooth module. My question: What or how to determine the pinout for BlueTooth module connection...

Great work! I like the new remote 3D design. On the new documentation page the link "How to flash bootloader on dongle" is broken. Link is under "Step by Step Instructions".

I have it, but have not built yet. Got off tract building the balancing robot.

A big AMEN and 2nd on that! Many thanks.

Deleted double post.

As an mbrusa user, I am very happy with my last configuration/flash ebike and motor wise. Having the wireless and ease of display on my phone would certainly be a PLUS! I really noticed the cadence giving assist way up high probably near 120 or so, no way to measure at the time. Very happy...

Ride today, finally after much bad WX and other stuff getting in the way. Really nice, never got above level 2, level 1 mostly running easily 18mph, going through top 4 gears for hills. 62c high temp. Really great, not sure I want to change anything at this point. Thanks to all who put in...

Bike was donated by a close friend, it is a "Specialized Fuse" with 3" tubeless tires and drop seat (the lever next to the keypad). I do have to reach for the keypad, could move the drop seat control over to right and move keypad closer, brake clamp is very minimal.

Mine:

I do have PLA, thanks for the printing tips. I will save the PETG for tough outdoors or in the car stuff. Do you use a release? I am on Ender 5 Pro with magnetic base, which is fine for PLA, but about to wear it out removing the PETG.

Printing today, still steep learning curve even just slicing. PETG is tough and sorta hard to print, but starting to get it I think. Switched from .4 head to .6, which made it somewhat easier. 250c print head and 70c bed. Still a little rough but close, great job on the design casainho!

@casainho It is an M2 .79 pitch plastic thread forming screw pan head phillips. Still looking for purchase link. Most are 100 pieces. Something like these, but you may need...

Sorry, my bad, memory is going at 75, damn it. Mine is blue.

My 3D printer came in last week. I'm learning Cura, Octoprint, free cad also. Some very good youtube tutorials 7 months old, helps a lot. Also HOVER over the mouse at bottom of screen in free cad and see what controls what. I'm at the point of trying to calibrate the printer as it is off too...