I am sorry if this question is answered in one of the 200 pages ahead, but I could not find it... My adaptto midi-e has blacked out and wont turn on. This is the short story:
*(not sure this part is connected to the problem now but...) I had a issue with hall sensor-errors always poping up when I changed to a gng mid motor. I swaped the hall sensord in the motor, and the same problem continued. I might have fibally found a weak soldier link behind the hall-connector on the harness to the adaptto... But never got to test this because the red power-on-switch cables broke off right outside the controller.
Then I stripped this cable it popped up two red cables in that wire. I picked the one it looked like had been the right one, but nothing happened. I then tryed the other (I believe I could see some very dim fast flickering in the screen for a short while) but no picture on screen... After pulling all my hear out I carefulle opened the controller to se if it was visible on the pcb which red cable was the right one for turning on. Funny thing is that on the inside, only one red lead came out of that cable. But my OHM meter tells me both red cables are connected to something, but not directly to each other.... Im lost... And my controller does not turn on. Please help
*(not sure this part is connected to the problem now but...) I had a issue with hall sensor-errors always poping up when I changed to a gng mid motor. I swaped the hall sensord in the motor, and the same problem continued. I might have fibally found a weak soldier link behind the hall-connector on the harness to the adaptto... But never got to test this because the red power-on-switch cables broke off right outside the controller.
Then I stripped this cable it popped up two red cables in that wire. I picked the one it looked like had been the right one, but nothing happened. I then tryed the other (I believe I could see some very dim fast flickering in the screen for a short while) but no picture on screen... After pulling all my hear out I carefulle opened the controller to se if it was visible on the pcb which red cable was the right one for turning on. Funny thing is that on the inside, only one red lead came out of that cable. But my OHM meter tells me both red cables are connected to something, but not directly to each other.... Im lost... And my controller does not turn on. Please help