More specs from the Yuneec site:
http://yuneeccouk.site.securepod.com/
For the paramotor:
Motor
Make: Yuneec ‘Power Drive 160’
Type: Direct Drive
Diameter: 160mm
Control: Internal Sensor
Voltage: 66.6V
Output: 10KW
Cooling: Integral motor Fan
Speed Controller
Make:Yuneec ‘Power Block’
Voltage:59 ~ 80V (Max)
Amperage: 250A / @80V (Max)
Audible Alarms: Power On / Start
Start Protection: 5 sec. Slow start (Initial activation)
Battery Protection: 59V Auto Cut
Hand Controller
Functions: Start, Stop, Throttle, Cruise
Display: 128 x 64 Pixel LCD
Connection: RS232 Data Cable (Detachable)
Alarms: Motor temperature, Low battery
Data Information: Voltage, Current, Throttle Position, Time, Motor/Controller Temperatures
Battery Pack
Style: Plug and Play
Type: Lithium Polymer (LiPo)
Voltage: 59 ~ 75V
Pack Info: 1 x 30Ah Pack (54cells/Pk)
Total Amperage: 30Ah (Standard) (60Ah with Additional Pack)
Weight: 12kg per 30Ah pack
Battery Protection: Internal PCB - Max Temp / Max Output
Charger
Make: Yuneec E-Charger
System: Cell Monitoring / Balancing
Data Display: 115 x 65mm LCD
Protection: Charger shut down on fault detection
Input: 230V AC
Flying Time: 25 ~ 30mins (Depending on rpm, weight and wing)
FAQ as well here:
http://yuneeccouk.site.securepod.com/paramotor_faq.html
Battery Protection
Each E-PAC battery pack has an internal circuit board. This measures the voltage and temperature of the pack and should the pack exceed set current output or a temperature in excess of 80C the pack will shut down.
Battery Type - Lithium Polymer
Lithium Polymer (LiPO) currently offers the most commercially affordable, high density, power source available today.
With a power density of 170 (this is 170W per Kilo)...
An internal processor will monitor the charge and output history of the pack to ensure that no abuse has taken place. The pack will also have an internal fuse system so that is case of damage or severe discharge the fuse will blow. This fuse will only be service replaceable.
The E-PAC balancing charger monitors all 54 cells in 3 battery packs all at the same time. This charger was specially designed at Yuneec and it is the only charger of its type in the world at present, capable of handing this number and capacity of cells. During charging it monitors all the cells holding back high charged cells whilst bringing up any lower cells. In the balancing charge cycle each cell is charged within 0.03Mv of each other. No other commercially available charger can do this and it represents a huge breakthrough for battery powered systems.
Charging Times
Following an increase in specification E-PAC now has two charging systems. One is a full balancing charger which operates as described in the charger section above. A full charge with the balancing charger takes approximately 3 hours.
The other is a standard charger. This charger can be used for quick charging and takes approximately 1.5 hours.
Yuneec’s LiPo battery packs require balance charging approximately every 5~10 charges charge’s and so the quick charger is used for normal charging in-between balance charges. Both chargers are required.
Fault Detection
The E-PAC controller and motor are fitted with sensors, these control the motor and regulate the operation but also give feedback and act as alarms. In case of high motor temperature the control handle vibrates allowing the pilot to view the data screen and adjuster the power setting to reduce temperature. If this is not done then the software automatically adjusts the power output to reduce the motor temperature.