Thecopterdr
100 mW
- Joined
- Oct 8, 2012
- Messages
- 39
I've got a brand new MXUS 3K and ZT 72-18 controller.
I thought I'd get it hooked up early in the project and have got the display working and showing voltage but not battery capacity. Temp is displayed and if I unplug the Hall sensor then I get an error symbol on the display.
I can't get a response out of the throttle. I plugged in one 24volt pack just to get the display going then paired up a couple to make 48 volts to run the motor. There haven't been any sparks or things plugged up that shouldn't be. All the plugs are different sizes and pretty idiot proof.
Has anybody had this problem or have any idea what might be going on?
I thought I'd get it hooked up early in the project and have got the display working and showing voltage but not battery capacity. Temp is displayed and if I unplug the Hall sensor then I get an error symbol on the display.
I can't get a response out of the throttle. I plugged in one 24volt pack just to get the display going then paired up a couple to make 48 volts to run the motor. There haven't been any sparks or things plugged up that shouldn't be. All the plugs are different sizes and pretty idiot proof.
Has anybody had this problem or have any idea what might be going on?