sven_nilsson
10 mW
- Joined
- May 10, 2014
- Messages
- 25
Hi there!
Could someone please tell me if the controller requires a battery connection to be programmed via USB ?
I installed the driver/software and I'm able to connect to COM19 which is the 485 interface.
The TX transmit light in the software is flashing, but RX is dead so there is no response from the controller.
The above result is without any batteries connected.
I also tried with a 30V PSU but then I read it needs something like 50V absolute minimum.
With 30V there was no feedback at all. No status LEDS, etc. Can this be right?
Regards
Could someone please tell me if the controller requires a battery connection to be programmed via USB ?
I installed the driver/software and I'm able to connect to COM19 which is the 485 interface.
The TX transmit light in the software is flashing, but RX is dead so there is no response from the controller.
The above result is without any batteries connected.
I also tried with a 30V PSU but then I read it needs something like 50V absolute minimum.
With 30V there was no feedback at all. No status LEDS, etc. Can this be right?
Regards