Source for dual motor mount to fit MBS Matrix trucks?

[LEVer]

It's 1/4 thick 6061 alu that supported 2 x 3.5lbs brushed motors, mounts and the horizontal bars. I would probably not go with 1/8, just 1/4 with big holes in the middle to make it lighter. Start with a few holes and then add more if needed.

As you can tell, these are not the MBS tires, they are wider. so the sprockets are pushed more inside, making the plate narrower than if I used MBS tires. Best to get 12" x 12" plate and cut it from there.

The L brackets I used are 1/8, but you have to use the horizontal bars or else they will bend.

 

[NJEV]

It's 1/4 thick 6061 alu that supported 2 x 3.5lbs brushed motors, mounts and the horizontal bars. I would probably not go with 1/8, just 1/4 with big holes in the middle to make it lighter. Start with a few holes and then add more if needed.

As you can tell, these are not the MBS tires, they are wider. so the sprockets are pushed more inside, making the plate narrower than if I used MBS tires. Best to get 12" x 12" plate and cut it from there.

The L brackets I used are 1/8, but you have to use the horizontal bars or else they will bend.

Can you please share that wheel setup. I am looking for a wider tire for my daily commuter and every MBS wheel I use ovals out in the summer. Time to make the move to a metal rear rim.

 

[LEVer]

Sure. It's e-glide's GT Kenda tires on MBS tri-spoke hubs for 9" tires. The tri-spoke hubs are plastic though, but they are tough.

http://www.e-glide.com/electric-skateboards-store/electric-skateboard-parts/wheels/gt-kenda-tire-set-detail

http://shop.mbs.com/accessories-355/mountainboard-wheels/hubs/mbs-tri-spoke-hubs-black.html

 

[kwoolf1]

Sure. It's e-glide's GT Kenda tires on MBS tri-spoke hubs for 9" tires. The tri-spoke hubs are plastic though, but they are tough.

http://www.e-glide.com/electric-skateboards-store/electric-skateboard-parts/wheels/gt-kenda-tire-set-detail

http://shop.mbs.com/accessories-355/mountainboard-wheels/hubs/mbs-tri-spoke-hubs-black.html

Thanks for these links. What tube(s) would you recommend for them? thanks

 

[LEVer]

http://www.electricscooterparts.com/tires.html

9x3.50-4 ( 9x3.5-4, 3.50-3.00/4 ) Tires section.