Hi, i have a nine Rh205C 7x9 motor, i use it with a KT controller(and a 72v battery), i need to insert some parameter through the display(KT LCD3) in order to correctly configure it, but i don't know these parameters, that are:
P1 = motor gear reduction ratio * number of rotor magnet pieces (range 1-255)
P2 is wheel speed pulse signal setting, if wheel generated 1 pulse signal by a revolution, P2 should be set as1. If wheel generated 6 pulse signals by a revolution, P2 should be set as 6. If users didn’t configure the pulse signal system, then P2 parameter
setting can be 0.
C2 is motor phase classification coding setting, it is served as identification parameter
of different phases of the motor when using sine wave drive and the default value is 0.
When C2 setting is 0, indicating that the used Quantum motor phase is an ordinary one.
When the setting is a certain value, indicating a particular motor phase is used (range 0-7)
Anyone can help me?
Also, considering that at 72v that motor should runs at 460rpm(wheel is 27.5"), and that the power should be enough(25A controller), i don't understand why the bike doesn't go over 50km/h(31mph), any idea?
P1 = motor gear reduction ratio * number of rotor magnet pieces (range 1-255)
P2 is wheel speed pulse signal setting, if wheel generated 1 pulse signal by a revolution, P2 should be set as1. If wheel generated 6 pulse signals by a revolution, P2 should be set as 6. If users didn’t configure the pulse signal system, then P2 parameter
setting can be 0.
C2 is motor phase classification coding setting, it is served as identification parameter
of different phases of the motor when using sine wave drive and the default value is 0.
When C2 setting is 0, indicating that the used Quantum motor phase is an ordinary one.
When the setting is a certain value, indicating a particular motor phase is used (range 0-7)
Anyone can help me?
Also, considering that at 72v that motor should runs at 460rpm(wheel is 27.5"), and that the power should be enough(25A controller), i don't understand why the bike doesn't go over 50km/h(31mph), any idea?