JamieWlcox
10 mW
- Joined
- Mar 5, 2018
- Messages
- 24
I have recently blown a few Chargers due to the polarity being on the opposite sides of a one way plug. So I have bought a resistor kit to fix the Chargers
After fixing I wanted to check the output voltage and amps to ensure proper use because I used a .33 ohm resistor which should have been a .1 ohm resistor I wanted to double-check the output
After doing so I checked all 3 chargers one of which the factory Seal had not been broken all measured between 56 and 59 volts. The Chargers were 2.5 and 3.0 amp Chargers
My question is they are putting out between 19-20 amps with no load
What am I confused about here how does a 2.5 amp charger put out 20 amps.
The battery is also charging to 57.4 volts that seems kind of high to me for a 48 volt battery
After fixing I wanted to check the output voltage and amps to ensure proper use because I used a .33 ohm resistor which should have been a .1 ohm resistor I wanted to double-check the output
After doing so I checked all 3 chargers one of which the factory Seal had not been broken all measured between 56 and 59 volts. The Chargers were 2.5 and 3.0 amp Chargers
My question is they are putting out between 19-20 amps with no load
What am I confused about here how does a 2.5 amp charger put out 20 amps.
The battery is also charging to 57.4 volts that seems kind of high to me for a 48 volt battery