Hello everyone,
I have a simple question and I hope there is someone out there who can solve my "problem".
I bought this cheap ESC (attachment) with a HUB motor for one of my projects. I use it for testing with 6S and it works fine. They say it can be used with 8S too and on the board I can see a very small "36V" logo upper left with some sort of jumper. Usually I would solder a bridge from the 36V pin to GND but I am not 100% sure. (Don't wanna burn something up ). Unfortunately there was so manual with this ESC (China :-/).
Perhaps someone knows it better than me, thanks!
Philipp
I have a simple question and I hope there is someone out there who can solve my "problem".
I bought this cheap ESC (attachment) with a HUB motor for one of my projects. I use it for testing with 6S and it works fine. They say it can be used with 8S too and on the board I can see a very small "36V" logo upper left with some sort of jumper. Usually I would solder a bridge from the 36V pin to GND but I am not 100% sure. (Don't wanna burn something up ). Unfortunately there was so manual with this ESC (China :-/).
Perhaps someone knows it better than me, thanks!
Philipp