DaTree
1 mW
uhh, i think its all wired correctly but obviously its not because my power connector only reads 16 volts, also the charge connecter reads the same 16v. its wierd because when i first get the reading it can be as high as 36v then i watch as it degrades down to 16v.
i dont know if maybe i need to do some programing with this thing before it will give me my full voltage or what ive done. the balance leads start with the positive lead which is soldered to the positive end of the battery, then each next balance lead is soldered to the negative side on the bus bar for each group then there is a negate balance lead that goes on the negative side of the battery. i followed this diagram, and included pictures with as much detail as i can get. Please haaalp
i dont know if maybe i need to do some programing with this thing before it will give me my full voltage or what ive done. the balance leads start with the positive lead which is soldered to the positive end of the battery, then each next balance lead is soldered to the negative side on the bus bar for each group then there is a negate balance lead that goes on the negative side of the battery. i followed this diagram, and included pictures with as much detail as i can get. Please haaalp
Attachments
-
s-l640.jpg54 KB · Views: 2,231
-
IMG_20191024_161533474.jpg203.4 KB · Views: 2,231
-
IMG_20191024_161514359.jpg116.3 KB · Views: 2,229
-
IMG_20191024_161506771.jpg130.4 KB · Views: 2,228
-
IMG_20191024_161258580.jpg177.4 KB · Views: 2,228
-
IMG_20191024_161254304.jpg173.3 KB · Views: 2,230
-
IMG_20191024_161250434.jpg198.4 KB · Views: 2,232