AHicks

Between the wife and I, we currently have 6 bikes, and I ride every day. 4 of these bikes are set up with KT controllers, and all have...

The LCD reset must mean he set C10 to Y, Then he must have had to put in the desired C info.

There's speed based PAS, and there's power based PAS. KT's "imitation torque control" is chinglish for power based PAS. It's that...

Just to take the throttle output testing a bit further... Those throttle output voltage numbers look great to start with, but perhaps...

Yup, looked at the manual and P3=1 sounds right. Bad memory.

Is this while actually riding the bike, or are you testing with the rear wheel off the ground? Doc's been riding KT a lot, so I trust...

No. Not at all. 1% throttle = 1% of the available power (not torque!) 25% throttle = 25% available power, etc. Your use of the word...

I don't know a thing about what the controller SHOULD be drawing, but I can tell you that the 3 KT controller equipped bikes I have now...

If you aren't already, get some Slime (or whatever brand you prefer) in that tube. I think you'll be amazed at how somewthing that...

Sales thread moved to for sale forum where selling things go.... ;)

Never seen a bike with a propeller.....

The Bafang shift sensor, stock on many/most Ultra equipped bikes, will defeat any delay set up in the controller parameters. The...

FYI - the parameter configurations are held in the display. There may be some you can hard wire with jumpers, but I would want more...

It's rarely pushed hard, but I have a 35a KT controller running a 1000w MAC 12t geared hub. Been running flawlessly, without even one...

I have no experience with the 20" stuff, but one of the reasons I got rid of my 26"x 4" fatty was when running pavement tires (quiet...