Recent content by camerons98

So that would require removing the side cover of the motor? I've never done that before.. is it a simple process? doesn't it ruin the seal on the side?

Few details about the bike: -MXUS 3000W V2 -LYEN 18 fet controller -20S 11aH 18650 pack Okay so I went to repair my bike after my accident last year where the wheel fell out the dropouts... After I put everything together and tested the throttle the wheel stuttered a few centimeters then froze...

Forgot to make it unlisted, there you go, should be able to view it now! EDIT: Just purchased a tester, should be here in a few weeks, once that arrives i'll update you all.

Sorry amberwolf forgot to reply to your post. Logically I'm thinking it can't be a FET issue otherwise it wouldn't have started working again the first time round? and it definitely can't be a LVC because I've LVC on the controller before and it takes at least a second for it to kick in again...

I tried googling about pull-up resistors but looks way out of my league.. i don't have much knowledge in electronics at all. I've shot a quick video on youtube to outline my setup and see if you can spot any obvious area's which might need a look into. My largest suspect for the possible cause...

I can't find the damn problem and it's starting to annoy me now! I don't have any spare parts that I can just swap out to try and find the problem.. I believe it could be the hall wires inside the motor potentially shorted together somehow.. I might crack open the motor tonight and take a look...

To give you all a quick update, i've been super busy but managed to do a bit more testing today. I measured the continuity from basically just outside the motor to the point where the phase wires are soldered in the controller (didn't feel like opening up the hub motor) and everything was fine...

Okay so to give you an update... I did a lot more diagnosing today yet I still cant find the problem.. I've tested all the halls and they're all giving correct voltages when I spin the wheel round by hand, so not that.. I then decided to swap some of the halls around and see if that got rid of...

I'll test to see if all the halls are working tomorrow with a multimeter, thanks for the link Ykick. I'll triple check the connections tomorrow but unless its something I cant obviously see then i'm sure its not :cry: Would a wrong hall combo result in the stuttering? maybe there's a 1% chance...

I know there's been many posts on this before in the past and I've tried searching up on them yet mines slightly different in that it was working before I took the bike apart. So I recently made a battery box and installed a new rear brake so my electric bike came to bits. Once I've put it all...

I've been looking into this for a while as well but there doesn't seem to be any solution at a reasonable price! All these GPS trackers specialized for bike are ridiculous prices.. I just want a small GPS tracker that has realtime and accurate tracking for a cheap price. If anyone finds any...

how do I check what type of breaker it is? all the chargers are working fine now so surely everything is okay?

Thanks for all your help guys its working perfectly! fully charged in just an hour and a half!

Removed the earth and they're powering up perfectly, thanks!! Final question.. do I just adjust the voltage pots so that its outputting 74v which is the nominal of my battery and then plug the battery in and it will charge by itself? Thanks!

I just purchased some Mean Well power supplies from ebay to charge my new 72v 14aH pack for my latest build but I've hooked 3 up in series to get 72v and whenever I plug it into the mains it trips the whole house instantly. I was under the impression that I could plug these directly into my...