Recent content by cascarabias

Good morning everyone, yesterday I changed my tsdz2 to v20.1c.3 LCD3, after making the changes in battery levels, etc. The screen displays "error 02" this is an assist torque error. I have read in the manual but I can't understand how to calibrate the torque assist. Can you help me? thank you

Thank you very much for the information, new software installed and working perfectly.

Good morning everyone, I have not written in the forum for a long time because until now my tsdz2 worked with 0.16 for kt3 lcd without any problem. I have decided to switch to a more modern software but I can't find anything for this screen. can someone help me locate it? thank you. sorry for my...

Does someone have a tsdz2 to sell? although it's spoiled! I just need the casing! I am from Spain!... Thanks

Hello Casahino! the other motor is broken. I bought a new engine, to install the v.17, is it the same as with the previous versions? Thanks

Thank YOU! Kisazul

hello, I had the same problem with the engine, the engine casing has cracked! What have you used to weld the case? Thank you

hello again, thanks for answering It is true that I am not an expert in electronics, I am an amateur. I'm just trying to make a battery for my ebike, I do not see a great difficulty to make this project. I have some doubts that I wanted to solve before continuing and now I think that they are...

hello, I'm building a 13s2p battery for the 48v tongsheng tsdz2 engine but in the voltage measurement it gives a total of 46.8v because I use Samsung INR18650-35E 3450mAh - 10A which are 3.6v. Will the motor work with this voltage or should I switch to 3.7v cells? Thank you

hello, what problems does firmware V0.13 cause? I use it every day to climb great slopes by mountain and I have only observed that with increased energy consumption, less kmts of travel compared to the original software of the tsdz2. It can be this by the screen configuration. I do not find any...

Hi, I've seen that the v.13 hex has been removed !! for serious problems .... I have installed this version and 200 kms without problem, problems are those of v.13hex? Should I change to v12 hex? Thank you.

https://postimg.cc/gallery/2ys600ps4/

I downloaded the images on this website, I really do not know how it works. I put the link, is it like this? https://cascarabias.imgbb.com/albums

hello again, I bought a new KT-LCD3 I flashed it to the V.13 hex and it works perfectly !!!. Really is a new engine, power, smoothness, no noise ... I only have one question: when the screen is on and I try to push the bike back, there is resistance from the engine to go backwards !!! This does...

hello, finally and after installing the new software, I could not run the lcd3 on my tsdz2, possibly my lcd3 is defective therefore I need to install the original software on the engine again. I tried to restore it from the backup done but it does not respond. Is there any variation in the...