Recent content by CiDi

I think it's for the CAN BMS to know when to start sending battery status messages.

The adjustable firmware is 46.2 not 46.2.yy

Bown is P+, orange is VCC or Key

A clarification, you can change the controller of an M600 with an M500, M510 and M560 have a different torque meter so they should be incompatible with each other. Has anyone checked this?

With the new controllers, levels can also be set in the M600.

Unfortunately in the M510 they changed the torquemeter and it is not compatible with the M500

Found

I would say yes, you have to reverse two phases on the stator connector, I don't know what advantages you could have though.

Hello, does anyone have the latest M600 43V firmware with boot 3.0-93? I saw version 132045.4 on a controller, but I can't find it online.

Fixed M600 controllers not updating. The newer controllers have BOOT 93 while the older ones have BOOT 89 and are not compatible with each other. The firmwares are recognized by the first hexadecimal code which can be 89 or 93. The new firmwares have settable levels through the application...

I can also make the modifications with the can analyzer, but only those of the levels, the same ones that you can modify with BESST PRO, the other modifications it does not accept.

Sorry, not P+ but the terminal called VCC or KEY. You recognize it because it is the only wire with voltage when the controller is off.

If you connect VCC+ with GND, the controller turns on in BESST mode. If you connect VCC+ with GND via resistor of 1 ohm for a few seconds, the controller turns on and off.

Currently the only firmware that works is 46.2

Do you have firmware 46.2?