Recent content by cody196

UPDATE: Apparently I went to test it this morning and motor didn't spin at first but now it does.

So the other day I decided to take out a 1 of the 2 shunts that my 48v to 72v controller had to cut my amps to 20 amps rather than 40 to test and see if my range would improve on my batteries and it did. I was able to ride into another county on 1 charge and all was working fine, even after the...

I got aq self sealing tube with good tire on front wheel so I shouldnt have to worry about anything right now as long as i am on pavement and not gravel or the shoulders where there is a lot of debris

Also the front hub is welded to the forks, so far it's doing well. I had to welded it cause the threads on the axle are stripped.

Are there other bikes with full suspension? Cause where I am in Michigan, the roads are terrible and there is cracks and holes in the roads everywhere. I rode on a no suspension bicycle before and it is horribly uncomfortable.

hey anyone got any suggestions to make my ebike look nicer? I have it working and everything is hooked up and working right, I have it on a full suspension bike frame and so far so good, but I am wondering on what I could do to make it look more nicer mainly for where the wires come out the...

Look at this on eBay http://www.ebay.com/itm/262893545999 Would that be a good battery to use for my Ebike rather than those lipos and I can only charge one at a time.

Well I went for a ride toiday and yup you guys were right one of the cells bursted. The other might still be good SO if i am careful I can make it a 3s pack and throw away that bursted one.

yeah, I would like to have decent range as long as i can go for a cheap price, preferably around $300 at most. I have a 40 amp controller and 44.4v nominal voltage used to have 60v nominal until cells went bad and wont hold a charge anymore. 10ah so if I do the math just right 50.4v x 40 amps =...

Okay So I have 3 Multistar 4s 10ah lipo packs and on the third one the sides are fatter than the others and for some reason Cell #1 was drained to 2.8v and all the other 3 cells were at 3.5 to 3.7v, any idea why the first cell drained too quicker than the others? Should I try to balance charge...

yep figured it out and i hooked it to a switch that i can simply flip back and forth on my handle bars

So like black to Pink or black to Grey and I should be good?

also is the three speed dial the red 3-pin connector with the Pink, Grey and black wires?

could you possibly do an example with the image with Paint or something or tell me which wire goes to which cause i dont want to frock anything up since I am using Lipo now.

Hey so I wanna do some range tests with a speed limiter with this controller I am using, i already did full throttle test with the LiPo batteries i got but i only get about 10 miles per charge at 30 to 35 mph so I wanna limit the speed or watts and it says in the diagram there is a power 350w...