Elinx

The assist levels aren't power levels, but percentages of motorassist. Turbo highest level gives 260% from your effort. You can set it...

Tried today, all good. Version v20.1C.6 released List of changes v20.1C.6 1 - Added PWM frequency choice, 18kHz or 19kHz. 2 - Added...

I just made an update on github. There is no change in the TSDZ8 firmware itself. I only removed all files related to the...

imho you haven't configured the settings with the configuration manual by hand. Are there any errors on the display if you try to pedal...

The controller is the same with different stock firmware, but 36V motor is different from 48V motor. See also the configurator manual...

Important note : I am currently preparing a new version that would not use the XLS sheet but directly the TSDZ2 configurator. To...

There are cheaper Loctite substitutes (RS R41, Holdtite R941, Holdit R41, Luoke LK641, Higlue 641), but relative expensive too. That is...

I have always ordered from Aliexpress or PSWpower and been OK. But did order a drive via Germany and yes it had a V2 controller but did...

There is a large bearing where the clutch is, and yes, the axle "contacts" only with the bushing. and the axle goes in quite easily...

Exactly. I used a couple of 14,5mm rubber O-rings (silicon greased) to fill that space. I glued the bearing inside the spider with...

Not a single seller can know which controller version is inside, but the V2 version had to do with EU regulations about max. power...

You are right about that, but realize that this Tsdz2 is missing the clutch on the maingear. Also in the past all gears had straight...

Correct, that extra bearing comes instead of that seal inside the spider. Same as the last (MAX) option with no seals, but two extra...

As long as there is work to be done I will continue, it is my hobby on bad winter days.

By the way there is also an update for the stock display version (Java Configurator). It is a confirmation of the 6-beta-1 version with...