Hello guys. Upgrading the cable from 8 awg to 6 awg, what length should i set the kweld on setting?
The totalt length is 1.5m.but the kweld is programed as 8 awg I assume.?
So after disassembling the packs, and making it to 3s3p, I weirdly still get 1800amp? What could be the reason? Could it be that I soldered the lugs for 4 awg, that may make it read wrong?
Have a question regarding calibration.
I use 3s4p spim08hp.
The cable I use from the battery to kweld is 4 awg wire, length of 300mm, so in cable setting I adjusted it to 1.5m. But I get overcurrent during calibration, and 1563a? The voltage of the battery is 11.66v.
Is my cable setting...
I bought a used ebike 350w 36v cheap. The battery is good i tested it and it went for about 20 miles, But i went down all the way to get all the juice out (test), and the battery shuts down at 30v. But when i try charging it, it seems it wont take charge. So i knew the bms shuts completly down...
Right know I'm checking the volt on the LCD, but could be even better if it could be set to shut off when it reaches a specific voltage, for safety reason :-) I will be back home on 2 day, then I will check for LCD on display :-)