Recent content by Joe

They call it nominal 250watts. Which is a power which can be held over a long period. Here this is what specialize write. https://support.specialized.com/turbo/en/turbo-full-power-systems/motors All full power motors provide 250w of nominal output. "Nominal" means the power output that the...

Zefal DEFLECTOR RS75. I added a stabiliser. I think it was this one. Cube Acid Stays for Mudguard Set MTB 65 extra long Stops it flapping around. It does help to keep the bike a bit cleaner. Look at the back of the seat and the rear suspension.

I use that one. It fits without a problem. It doesn't need the special bolt that screws onto the shaft. Just the 4 screws. It's very stable and does a great job. Hasn't got in the way either.

Snapped my HL belt yesterday. 2000km. Not bad. Installed a spare, so that's on, and ran the bike in full mode without a problem. I was wondering if the extra power had broken it, but I think now, after a ride, it was just unlucky.

I certainly notice the difference. It's pulls much stronger than before. Love the 40mm motor. I don't have any stuttering. This is how I did. I charged the battery to 100%. Then loaded my LMX 166 configuration and selected mode 3. Then did a full auto setup on the motor, and SAVE that to the...

With this ratchet removal tool the job took a few minutes. Many Thanks to LMX. Fantastic tool. The broken bearing tapped out easily and the new bearing are now in.

LMX fantastic customer support. I’ve got myself into a bit of a mess. One of those Paws of the ratchet fell off and landed in the hub bearing without me realising it. When I tighten up the wheel. Well that was that with the bearing. To remove that bearing, the ratchet ring. 48T ca. 34mm outer...

I removed my old 30mm motor and installed the 40mm motor yesterday. I removed the covers and swapped them. I didn’t want the LMX logo. Both motors look exactly the same. Both IPM. I couldn’t see a difference between a 30mm and a 40mm motor. Maybe I missed it. Does anyone know what the...

CD,I was just on the Nuculas site and see they have a new firmware. I downloaded it but haven't installed it. I was in the middle of their configuration page and found that in each mode S1,2 & 3 there is a PAS disabled and a PAS scale 0-100%. Have a look to see what yours says.

These are my settings from a few years ago. I haven’t checked them for a while. I changed the PAS filter to 2 kHz and the PAS time out to 0.02. That fixed the power continuation after I stopped peddling. That grinding noise. We’re had that before. I thought it was the bearing. It turned out to...

Why not stand the batteries up-right and have layer on top (laying down) or tripple layer if it fits. I still think you can get more in if the side frame is reduced and then strengthened.The whole space could be filled.

Hi CD. I really need help with batteries. I have no idea and want more power. I‘m very close to cutting the side frame to allow a sideways slip in and strengthening the frame with a stainless steel flat linear bearing guide under the battery holder. Or on the outside. It would allow a much...

Hi CD, have you noticed any change with the 40mm motor. I have one which I haven‘t fitted yet too.

I fixed that problem. Go to Page 24. Has anyone tried the Jumbo shark battery? EM3ev 52V (14S5P) Jumbo Shark Ebike Battery | EM3ev

Hi CD Here‘s a picture of the your 15T and the omega belt HL. Fits perfectly. You do have to pull it tight. (that‘s my spare belt, 2 years sitting in the cubboard) Since installing the 15T steel, it‘s never slipped. I am looking at the rear cog of the LMX56. Much smaller. I am hoping they will...