Jrbe

Found some time to write about this. I'm glad its finally out there. I hope this raises some interest...

Why not get some fiberglass or Kevlar pulp? Baking soda is an accelerant for super glue.

Greetings people. A set of performance plots for the MP2. Results are based on the latest MESC firmware build with field weakening...

Thanks for sharing your research PaulD! To add to amberwolf's post, if the additives are not well encapsulated it could make a salt...

Cool advantage of sodium bicarbonate: it will turn into sodium carbonate if heated too much, but it will slowly turn *back* into sodium...

Thanks for the feedback Luke and Amberwolf. Regarding the waterproofness of silicone, it does seem to be used successfully in wet...

Thanks for your feedback. I will do a bit of research on this. I did a quick 1000V hipot test without issue. @lgarczyn - I will run a...

I did this work almost a year ago following a conversation with Luke (LFP) who mentioned he was working on endothermic fillers that...

From post #7, BD - "So i left this for last because it's the juicyest bit :) First - SMD Pads, because the TH bump on the other side...

Regarding bus bars. They dont need to be segmented. Have a look at some of the bus bars methods at this link and let me know if you have...

I've heard this mentioned a bunch, but the copper layers in the pcb would likely separate / delaminate as well if it was an issue. Does...

I think they're using the front axle / motor in Formula E for regen only. I hope their packaging and build efficiencies will end up in...

Thanks for posting this, it's really interesting to see inside. It's clear they have some talented engineers. I'm not sure if this is...

Hi everybody. Just merged v0.4 to main. contains quite a few small changes improvements - see readme :) Br,

Munro posted a new vid showing the rear Lucid motor assm.. Center diff, stacked halbach arrays, and continuous wave windings! Worth a...