knightrider

I will say of the many kits that I have installed. The CYC stuff seems to present more problems. The BBS kits aside from obtaining a...

OK, the left side CYC refer to as a "Left BB Cup"; this contains one of the spindle bearings. There is a small issue with this where the...

Yea blue will hold just fine I just would prefer not to use it. The damn jamb nut should hold but is not. If you load the jamb nut as to...

The lock nut on the left side would be the locking nut I would think. Not the jamb nut with the allen sets. All motors whether bafang or...

Now with all the talk about dragging and lockrings not being torqued well, chainrings that can't be removed without BB removal? Sounds...

The BB spindle removal isn't that complicated. Just need to loosen the lock ring and pop the spindle out. IMO this is worth the...

Correct, I ride in 90s F all the time and have had no issue using continuous up to 750W. Above that it might get sketchy, especially...

I did sulpher mountain road today. 12+ miles of good climbing and the motor handled it like a champ! Motor temp got to about 170° f on...

And their dealers are not ready for primetime, either. Selling is easy... but support, repairs and warranty stuff, not so much. Nor is...

I think the Photon doesn`t like very much side load put on it with the tightening nut and the locking ring. Mine wants to loosen on its...

And by the way I would like to confirm that my wife's Photon motor have clocked 3500 km without any issue.

Amen on the holding up or re-install the HD.

Have built many e bikes with both Bafang and CYC drives. But this Photon unit I have on a steel framed marin el roy refuses to stay...

As @raylo32 wrote, the Photon looks after itself, so I don't have to - and I too have pushed on it hard (at 2kw).