Recent content by Mad Huey

  1. M

    Norco Aline and Kevlar/carbon tank

    Guess what i just picked up for $600 Was searching the forum for best way to mount battery and of course SamD is agead of the pack again
  2. M

    How to add conformal coating to a BMS?

    Follow post
  3. M

    Ping Battery Dead Cell Group - fix or sell Perth

    What size is the pack. I have a ping 48x30A pack that i run at 2c (60A) and have added/fixed several BMS that have failed due to getting rain on board. Have also rewired battery before too. I am in QLD and could fix it if you ship it to me
  4. M

    Clyte hs3540 runs smooth then shudders then repeats

    Thanks to Amberwolf and Dogman Dan for your diagnosis. It was the undamaged looking insulation on the wires coming straight off the hall sensors within the hub. Its running nice and smooth again now. The bonus is that in the time it took to fix from day it started its tantrum i purchased a Mxus...
  5. M

    Clyte hs3540 runs smooth then shudders then repeats

    Thanks for the reply amberwolf. I didnt do a thing to the controller as it all ran fine after fixing the melted wires inside the motor. It was a week or so later that i got a flat tyre which meant unplugging hall and phase wires to remove wheel from frame and replace tube etc. it was after...
  6. M

    Clyte hs3540 runs smooth then shudders then repeats

    Hi I have a crystalyte hs3540 running 48x60A Lyen 18FET 4110 and have replaced hall sensirs before after motor turned out of axle and pulled all wires etc. (that was when i had Lyen 9FET and 48x30a) Running regen and at 60A the motor locked up down a long steep hill as the phase wires melted to...
See more
Back
Top