mbrusa

I have done the first 2 items for sure. Pretty sure I also have 3.0=1 "calibrated" enabled. Just to be sure, I powered up the system to...

The best mode is Power assist, especially for gravel bikes and mountain bikes.

Yes it's true, the assistance levels in cadence mode use about half of the available scale, even less if you set the maximum power to...

The latest version for LCD3 is the one you find in signature v20.1C.4-3-LCD3, there are no further versions and there will be no further...

If you have already done the calibration by entering the values of "Pedal torque ADC offset" (without weight) in 10.9 and "Pedal torque...

Sure, you can build the torque sensor curve with multiple measurement points, but only in theory. I'm not going to propose a complicated...

My previous answer was about the accuracy of human power. Human power can be useful if needed, I myself use it when I do long rides with...

Maybe I wasn't clear, if it doesn't reset to 54.1V, you need to set a lower value. Try 53.3V (4.1V per cell) it should work, otherwise...

To get an accurate human power value, you need to do the full calibration, including the weight one. But the torque sensor response is...

You have to decrease "Reset at voltage" until you get the reset with the battery charged at 100%. For the "Auto" reset when the battery...

The noise before E07 is not normal, it is a symptom of something wrong, hard to say what. Is the motor new? Before installing OSF did it...

Thanks, it would be appropriate to do so if the participants were going to continue with this new topic, but I don't think they are...

I didn't think it would come to a warning from the moderator, but at this point it was necessary.

Limiting the maximum power to 250W is, in my opinion, an unnecessary precaution. If you purchased the 36V/250W motor, there is no...

We have already talked about powering the display from the battery.