Recent content by MelbourneBBS02

I don't think there's a chance that the display's cables are reversed. I'll try your other suggestion as soon as I get a chance. Sometimes you need a break from fixing things, so in frustration you don't break things while fixing things :|

As I was pulling everything and rewiring it, I encountered a new message on the screen. "Voltage Adjust.... Failed" when I hold all buttons down https://imgur.com/a/7tbIhLb Now instead of going to the normal display when the power button is held, the display asks for a pin which I can't enter...

I have checked for continuity and shorts along the wiring harness with a multimeter. Everything is the way that it should be! I also took the motor apart completely and checked the connections and integrity of everything. Everything seemed fine except for damage to the green phase cable coating...

Thanks for your reply. I have a hunch that you are on the money re a short. These issues started after I rerouted the wiring harness. I tried to clean up the wiring but probably didn't give it enough slack at the display end so it was under tension when the bars turned excessively. I've done...

The weird thing is that I've replaced everything but the motor, but the motor works fine! It seems likey a communication issue between the motor and the controller.

Unfortunately 30H is a bit more vague than 'wiring harness' related and relates to a 'communication error' generally. The BBS02 does not require a speed sensor hooked up (or a magnet to pass by the sensor) for the display to power on. I tested this to be the case prior to installing the unit...

Thanks for your reply. The unit is currently off the bike for testing. Whether or not the magnet is aligned properly is not relevant to the issues I described, as the unit doesn't require the speed sensor or magnet installed to turn on.

Hi Everyone, I'm at wit's end, having read every piece of information regarding Error 30H on the net and being unsure whether to sell my parts or to sink more money into getting my BBS02 back up to speed. A few months ago, my display began giving me the ‘Error 30H’ message and then ceased...