Hi fechter
Thank you very much for responding to me;-)
My located is Denmark...
I'm cautious about buying if more defective BLDC Controller!
Yours sincerely
Monie
Hi fechter
"Maybe time for a new controller. Ones like that are pretty inexpensive."
Yeah, you're right fechter ...
Can you help me with another BLDC Controller, with the following technical data:
1: Max 48Volt
2: Ca. 300 - 500Watt
3: And with the possibility of using the potimeter;-)
Yours...
Hi, fechter
Thank you very much for responding to me.
Has test "S" (SV or ST?) ... But without result for speed regulation with potmeter.
And one labeled with PWM with find square signal shown on oscilloscope!
Motor runs at full speed, even though the throttle wires are not connected to...
Hi fechter
Thank you very much for responding to me.
Reply 1: Where does the the green wire from the hall connector attach on?
Is connected to point "v" the board?
2: See pictures below of PCB layout:
Hope you can use the above picture?
Yours sincerely
Monie
Hi fechter
Thank you very much for responding to me.
I can not see where it goes wrong. But cable to the potmeter does not work!
Have tried a lot with many options but without results.
Yours sincerely
Monie
Hi,fechter
OK, The picture is a little blurry.
Will try with a better picture below!
What location on PCB Layout should the center of the potimete be connected to
Will you check this location?
Thank you very much for your great patience with me and the problem;-)
Yours sincerely
Monie
Hi, fechter
Under PCB layout - red circle = "V" has direct connection to the green cable to the center of the potimeter!
So the connection is OK!
But the speed control system still does not work yet?
Yours sincerely
Monie
HI Pfnyc
Hi, thank you very much.
But the type of controller I used is not the same type you use.
But throttle wires colorcoder are not the same as you use.
But it gives a good guide.
Yours sincerely
Monie
Hello everyone
Below you can see 3 pictures:
Hope you can see something?
But otherwise, I would like your help with another Speed control that can be used with a potentiometer.
Do you want to go through a web link to your proposal for a speed control.
Technical wishes:
48 Volt
Just as small...
Hi fechter and Glyn
Have tried with all ground wire to connect same and lead them to ground (Gnd - Black).
This did not solve the problem for a smoothly controlled speed.
Here are the pictures below!
Is there anyone who can help with a simple diagram for connecting to the potentiometer as...
Hello everyone
Is there anyone who can help with a simple diagram for connecting to the potentiometer as speed control for the device below ;-)
Which cord color should be used...