Recent content by nassal

Hi there, did you find out what the problem was? My tsdz2 shaft has a play and it is getting worse. Thanks

I have the same issue, can’t find details info how to do it. I have tried and none of the link in either pageS mentioned is working. :( https://github.com/emmebrusa/TSDZ2-Smart-EBike-1/wiki https://github.com/emmebrusa/TSDZ2-Smart-EBike-1

Thanks for editing Features and configurations. Got the throttle going now. I believe pedal assist not working because PAS has beeb damaged, due to wrong wiring and not disconnecting the battery during the firmware upgrade. Only my self to blame. New parts it on the way. Thanks for great work...

Just tried it on assist level 1, 2, 10, no throttle. I tried up button long press, up and down button long press.

I have checked the Configuration and checked agin. have reset default value, on assist level 0 still virtual throttle doesn’t work. I have flashed the firmware again and no different. Only thing is works is walk assist. Any more advise?? Thanks 😰

I have checked the configuration according ti instruction. The only thing works is walk mode. Have flash the latest version alpha.4, it didn’t make different, virtual throttle doesn’t work. Tried stock firmware, no pedal assist again but throttle works. I can’t use throttle with OSF as I used...

When it comes to technical and programming!, I am dumb, I have no idea what you just said, but I will look into it and will learn. Thanks

Yes walk mode works!!. Will check the configuration. Thanks

Thank, I will do that. I used the throttle wire for heat sensor, so no throttle. I damaged my 850c during the programming. Forget to disconnect the battery and by mistake used the 8pin connecter instead of speed sensor connector to programme and had a short circuit, after that I flash the stock...

I swapped the RX and TX wire,Communication is established now but no Pedal assist 😬. Use to have 850 which is not working any more. Got a 860 now and flashed it with first 860 display firmware was available and program code successfully verified. I thought it will be more stable one. Any idea...

Please help. just flash the v0.7.0 to 860 display but doesn’t communicate with TSDZ2, it shows errors brakes. Flash the TSDZ2 with v0.56.0. Breaks connect to green and black wire. Any idea what is wrong.

Thanks, I can change display front settings now, can’t change time/km to mile and can’t get to display configuration. 850c v0.6.2 and v0.51.0 hex. have installed temperature sensor but on the display, T sensor is on 0 all the time. Up and down is wrong way round, not Physically though. up button...

Found configuration menu, I think it is to do with programming. I just what to know how to access 850 setting!!. Double-clicking on/off doesn’t bring up the display settings.

Found configuration menu, I think it is to do with programming. I just what to know how to access 850 setting!!. Double-clicking on/off doesn’t bring uk the display settings.