Recent content by Nfer

I have been riding with the v20.1C.2 beta for a couple of weeks without any issue. I believe it makes less noise than the previous version. Good job!

Have been using 20.c3 and SW102 since it was released without any issue. Interesting. can you share the values you used in the config menus?

Why are you using v20.1C.2?

First you have to open the display and install the FW with the cables. It will active the bluetooth for future updates using the NRF software. https://github-wiki-see.page/m/OpenSourceEBike/TSDZ2_wiki/wiki/Open-SW102-by-cutting-keypad-base-and-solder-SWD-wires#Open_SW102

I think Trip function is only for 860 display

Great!!!!

Does it have the new controller? where did you buy it?

Great!!!

Mbrusa, how is the 20.1C.3-NEW trial going? is it safe?

is it ok to use the SW102-otaupdate v20.1.c2 with the v20.1.c3.hex?

Where did you order it? PSWPower?

Without torque sensor calibration I ride on level 3 of power asist mode (70%) with PWM of 254 90% of the time. The calibration gave me a narrow ADC range from 198 to 280, and still got to 254 PWM easily. So I increased the maximum ADC to 380 and now some effort is required to get to the maximum...

I checked this morning the pwm values during the commute. Urban environment, lots of red lights and stops. With the boost active with 250 factor and 25 step the pwm is 254 from light to light. Is this the reason why the battery consumption is higher than with 1.0.0 version? I changed the step...

Interesting. Do you guys have the boost option enable?

I followed the wiki https://github.com/OpenSourceEBike/TSDZ2_wiki/wiki/Flash-the-bootloader-and-firmware-on-SW102-using-SWD