Recent content by rlewis

I am trying to keep my wiring clean and eliminate any wires that I can on my CA3. Instead of running the display cable, PAS cable and the temperature cable to the bikes midsection. I would like to run a single through frame wire. I was planning on 6 wires for the display, 1 for PAS, 1 temp. Then...

This is where I'm leaning for battery, controller and water bottle. It's a good bit higher in the frame than I originally wanted, but is a compromise for water.

Thanks again for the feedback. I keep changing my mind... You guys are bringing up great points. Plan to drill and install a rivnut to anchor the battery good. First hole/scratch needs to be thought out. The battery is heavy for what it is. 52v 17.5ah 40a bms. Not a lighter weight version. So I...

Thank you for your responses so far! I get the low center of gravity as a concept, but personally have no practical experience. So I appreciate your insite. As an engineer, instinctively, I think vertical mount will provide a marginally less COG. Being that the weight impact "lands" near the...

Thank you for your responses so far! I get the low center of gravity as a concept, but personally have no practical experience. So I appreciate your insite. As an engineer, instinctively, I think vertical mount will provide a lower COG. Being that the weight y axis "lands" near the crankset.

Traditional downtube mount or seatpost tube mount?

Is there any reason that this display couldn't be used for a hub motor. Such as mac or leaf? Everything that I have read mentions the bafang mid drives only....

neptronix thank you for your detailed information on leaf motor both on YouTube and the forums. I am very interested in the 6t winding, 60a programmable controller and a 27.5 wheel. It s also worth mentioning that I live in live in the foothills of NC mostly flat with a some shorter hills. Your...