Recent content by rscamp

  1. rscamp

    CYC Photon 3D models and settings sheet

    Awesome Jonna. That spreadsheet will be helpful. And already in Canadian units. Cool. :cool: With regard to auxiliary parts, I designed a speedo mount and an anti-rotation bracket assembly that is strong enough to take the torque reaction force. The speedo mount is custom to mount to the...
  2. rscamp

    Why shouldn't i build a Neumotor RC + planetary gear reduction drive?

    I adapted a Neugart gearbox to an Astro motor for a chain puller drive. It worked pretty well. I suspect the Neugart gearbox is somewhat more robust though.
  3. rscamp

    CYC PHOTON

    (y)
  4. rscamp

    CYC PHOTON

    Could it be high lubricant viscosity causing sticking of the sprag elements at low temperature?
  5. rscamp

    Cycle Analyst V3 preview and first beta release

    I concur. Such a display takes the eyes off the job at hand for an extended period while waiting for it to change. It wouldn't surprise me if there is a human factors engineering spec somewhere for human-operated equipment that disallows this for safety reasons...
  6. rscamp

    Cycle Analyst V3 preview and first beta release

    Is it possible to change the logic to look for the minimum allowable time to the next magnet? This would give a three magnet setup more of an advantage.
  7. rscamp

    Bafang C961 display speedometer problem greater than 27mph

    Agreed. It just can't keep up. I even tried a strong rare earth magnet and it made no difference. It is what it is...
  8. rscamp

    Bafang C961 display speedometer problem greater than 27mph

    I have the exact same hardware and the same problem on a trike with a 20 in rear wheel but in metric units. In my case, when going over about 55 km/h it displays half the actual speed. Adjusting the magnet or pickup positions has no effect on this behaviour...
  9. rscamp

    18650 cells that are unsolderable.

    The video shows the wrong tool and the wrong method for the job and results in heat being applied at least 4X longer than necessary. Instead, after preparation coil up the total amount of solder required on top of the battery and use a hammerhead tip.
  10. rscamp

    Galileo/Newton agree-- 9/11 was an inside job!

    I can't justify spending a lot of time on this. The evidence doesn't support it. Is there doubt? Sure. But the cherry picking is out of hand. "Hand waving" is a good description. There is a lot of motivated reasoning. Conflicting evidence is not being addressed or is being ignored. The...
  11. rscamp

    Galileo/Newton agree-- 9/11 was an inside job!

    http://www.civil.northwestern.edu/people/bazant/PDFs/Papers/476.pdf
  12. rscamp

    Galileo/Newton agree-- 9/11 was an inside job!

    http://www.tms.org/pubs/journals/jom/0112/eagar/eagar-0112.html http://www.tms.org/pubs/journals/JOM/0711/banovic-0711.html
  13. rscamp

    Galileo/Newton agree-- 9/11 was an inside job!

    https://www.metabunk.org/debunked-ae911truths-wtc7-explosive-demolition-hypothesis.t1727/
Back
Top