scianiac

From my experience though poggies should be done before heated or super heavy gloves. If they are not enough combined with thinner...

While I only spent a min researching it, it seems that most public charge points in Australia use renewable sources. Presumably to stop...

For fixed applications magnet wire would be a good option, although for heated grips I think the super cheap carbon tape plastic ones...

I made the jacket using the 40ga teflon which was 12V and later also made a seat heater with that but while it did work for quite awhile...

"Ideal" diodes are not actually diodes, they are a mosfet that is controlled by a chip so that when the mosfet is driven on the voltage...

I've been using them for awhile now and they have some pros and cons depending on how you are using them. They do seem to compress more...

I believe the answer is both, if both batteries are close enough to the same voltage than when drawing higher loads the higher voltage...

Honestly you would probably be better off getting the VESC to drive the stock motor in terms of complexity. That outrunner will only be...

The Teflon wire was forever ago so I can't recall where, but it was a little tricky to find so small. The silicone wire can be found...

I think for most people heated pants and vest shouldn't be needed and cost more and be more complex than good gear, I mean snowmobilers...

Although I foresee one small issue, it would require a BMS that can switch the positive, like a contactor BMS. You have to keep chassis...

I think you missed my point, honestly a 100A BMS would be fine depending how many accessories you have. The idea is the starter solenoid...

I too freeze easily, keeping my hands and feet warm is a challenge but with enough gear it's certainly possible. Previously this was all...

I too have had dreams of replacing this giant block of lead with some nice LFP cells but yeah many of the commercial options are...

Pretty sure I read that article when I was researching before building mine, unfortunately all the devices shown are either hard to...