Recent content by Seven

Was that bike ever registered?

Haven't actually measured the socket itself, I need to upgrade my cable going to the plug as its my weak point

It will fit this though http://www.neutrik.com/en/speakon/speakon-chassis-connectors/nl4mp Although the current rating is a little lower, it's what I'm using @ 30a out of my eaton,

My bad that cover will not fit,

It all depends on what socket you are using, NLT4FX is a plug, what sockets are you using on your bikes, that cover will fit quite a few sockets that will accept the NLT4FX but it depends on which one you've installed

If you are going down the neutrik speakon route (which you should) use one of these covers http://www.neutrik.us/en-us/speakon/speakon-chassis-connectors-accessories/sccd-w

This is not the photo you've seen before but here is what I've done, all I've done is fabricated some small right angle brackets and bolted them through the side cover bolts

I've also noticed ovs drastically changes the autodetect values and believe it will change the behaviour of the motor from 0 rpm

Strange, you shouldn't have any trouble with the domino though, are you planning on hooking up the micro switch?

I am using a domino on my max-e, it works perfectly and has for the last 18months (4000kms) I do not have the micro switch hooked up though as I'm using the variable regen. It sounds like you need to run the throttle linear mapping routine,

Awesome work mate, can't wait to see it with a licence plate on it, am I right in thinking this will be the first Ebike registered in Aus?

The ability to quickly switch between a 100% charge and 80% charge and fast and regular speed charging in the charge screen, please. But I'd prefer the DC-DC converter for lights first

Hey guys anyone in Australia have a spare adaptto screen? I've just smashed mine when my bike fell over and now all it does is just flash the backlight and the bike does not go, I'm in Perth so the closer the better, thanks, on a side note does anyone know the way to bypass the screen while I'm...

I'm also watching closely for the registration and ADRs, I wish you Godspeed with your endeavour

Hi Jay, here is my settings for the QS V3 have a go with them, let me know, Dave.