i've solved the problem only with a very short cable (maube less than 10 cm) between usb stick and speed connector......looking in front the connector 5 v on top, ground left bottom e swim right bottom...that's all.(wiki instruction)
try with 5 cm programming cable and a long usb male/female...
Hi guys,
found solution!!! :bigthumb:
the cables programming between usb keys and speed sensor connector was too long!!!!!
i've used a 15 cm cable and now all it's ok!!!
Communication error disappear...!!!!
tks to all! :mrgreen:
Hi guys,
found solution!!! :bigthumb:
the cables programming between usb keys and speed sensor connector was too long!!!!!
i've used a 15 cm cable and now all it's ok!!!
Communication error disappear...!!!!
tks to all! :mrgreen:
Hello..!
i have the same problem...Communication error flashing the motor ctrl.....
flashed lcd3 in a few minutes all ok.
is very frustrating!
there is no way to flash the motor ctrl......
i'll try with another 2 different st link v2 keys and let you knoe results...!
tks to all.
tried to flash original controller 6 wires installed in the motor on a bike.
done with system switched on (battery 36 volt connected)
connected for flashing: ground / reset / swim.
always the same error...!
very frustating...!! :|
i've have bought 2 new st link v2 clone different...
Hello i'm Steven from Rome - Italy and i'm an enthusiast owner of tsdz2 350w; i remain very hit from the open source fw for this motor and i would like to convert the motor into it.
i bought 1 lcd3 and a new 8 pin cable motor controller from PSPW.(i want to mantain the old system ctrl + lcd5...