sharinginfos

is it ok to bump ?

humm interesting.... thanks for pointing it out. lets see what is next..

HI timmmlet. thanks for answering, did you have the tool to test the spec to compare it to the spec of their report tests? Do they tell...

Hi so with those used cell do you advise me to use an active balance board ? to do the initial balancing or for further on? Maybe i...

Hi are you saying to only use one at the time ex: put the bms balance fct off use the active balancer and one it has done its job unplug...

by circuit fail, are you talking specifically about the active balancercuircuitboard? Is there a way to install an active balancer in a...

Hi could you show an example of a failsafe cutoff to buy? maybe a drawing . When you write charger's regulation circuit fail, concretely...

from what i understand the wiseblue cannot stop at 3.1v but b6 can. my plan is to do capacity test (i dont know yet how to do it but ill...

hum anyone would happen to know how to answer the post #37 i made following docw009 's sharing #35?

hi can you express this with other words? i dont understand what you are trying to convey. And how long would it take to capacity test...

I commited! ibought 6 modules. before the ship it i have a small window of time to add stuff from their site. what could be usefull...

Hi Unless there is a good reason to discharge or test the full modules, i dont intend to do that since I will test the 2p individually...

I intend to only use the b6 charger to test capacity and charge it back to a voltage that does not damage the cell that will have to...

Any reason to choose one over the other?