Sturmey

If I may add to what you said, most/many multimeters anyhow are only specified/guareenteed as accurate at best to about 1% plus one...

Sorry, it does not have custom firmware.

It is indeed phase current. It circulates through the motor. Freewheeling/flyback current adds to the battery current and increases...

Dont forget that extra 'freewheeling/flyback' current over and above battery current is generated caused by collapse of motors magnetic...

Just a thought. Sometimes a light thin wire is better in this application in that if it does short, it will burn/fuse quickly and do...

Your suggestion reminds me of the 'End Cell Switch' that was used on old 50 volt strowger telephone switch power supplies to boost the...

In Europe, there is also a requirement under EN15194 as quoted below. They may not be required with certain torque sensors as they may...

I have put diodes in series with charger output that seems to work although it does slow up the switching 'on' of the finish green...

As well as transmitting data, the coils also transmit a small amount of power for the hall sensor in the spindle (like a transformer)...

Circuit breakers will typically carry multiples of its rated current for a certain time before it trips (e.g double its rating for 50...