Recent content by vass

I really need to do this, you seem to have taken the tsdz2 to another level

I had a similar problem when i didnt use the metal part that has 2 holes that bolts into the motor. The motor "twisted" a little and was very hard to pedal and made strange noises. removed put it back and all good.

If i remember correctly if you disable the "odo compensation" its faster to display speed. Regarding the changes of parameters, just tell him/her if anything fells strange or something strange is displayed to just shutdown the lcd5 and then power again, it will revert to stock settings :D

Strange, then that part of the controller is ok , try to put factory software back just to test the short didnt do something to the one on the controller (like wipping the chip were it is stored). Did you also test the battery? maybe the short fried the bms and the batt is dead :(

It means that its probably dead and you need a new one , you could try to check if the programming software (STVisualProgrammer) can read/write from and to it, but my guess is you fried it (with luck the lcd is ok)

Try to put the stock firmware on just to ensure its not a bad config on osf (or a strange bug).

Can you pedal with the motor off easly ? did you try to run the motor out of the bike. I had a "similar" problem when i didnt use the metal part (dunno the name) on the case side on my full susp bike. I think the motor twisted or something without that part, it became harder to pedal (and had...

Waiting for the how to :) (and the price for the "oil" :mrgreen: ) When i wanted to use "oil" for cooling my gaming pc i read a little bit about it, in the end mineral oil was the cheapest way to do it but it dmgs plastic in the long run (so maybe a controller failure will happen if used here)...

.... Removed (offtopic)

Yeah, a BBSHD with torque sensor, altough expensive could be a good thing (basicaly an ultra for diy), maybe the Lightest ebike kit will be good enough. But tongsheng could do it very easly with the help off you guys, some thermal pads and a temperature sensor and a pcb with bluetooth would make...

damn Casainho and mspider on the same place :). Tongsheng should just get you guys onboard and do a tsdz3 with your ideias and code (and some mods for thermal stuff) and have a damn nice motor from factory (a factory could do this with 50 euros or less i would say)

hehehe tsdz2 dont like portuguese people or the north, had also alot off issues when i was in vacations in Viana do Castelo. In the end all off them were caused by my mistakes :) (bad soldering of the brake sensor and temp sensor overtightning the motor and riding on sand :roll: ) Also is...

Niceeeee, also nice ride and view :)

If they came from outside Europe you should have to pay, here in Portugal i would pay 25% over the price of the item+shipping (yeah its stupid like hell to combine postage costs...)

mspider65 do you think making the cable to the lcd5 longer will affect anything? (like controller cable -> 1m cable to pcb -> 1m oem cable to LC5. i want also to have the pcb near the phone (inside a box on a phone holder for extra security) but dont want to splice the oem wiring (so i will...