woofnbike

thanks again very much. might take me a bit to get back at it, but when i do, i'll report back ... prolly with more questions.

let's see ... yes, you are right, i heard back from the seller and the levels do indeed refer to PAS. good call and catch! as to the...

tried the limiter wire. it slowed the scooter way down, maybe even too much. at the same time, the throttle dead zone increased to...

i'll see about the halls. and will see if i can get at the limiter wire today. maybe order a new throttle from amazon, too, and see if...

could the problem be my motor has bad halls, which is does, and the controller/led is made for both hall and without hall and i'm...

btw / can you tell me which wires on my controller are the 3-speed switch ones? the pedal assists?

okay, this is what i ended up getting. cut the ground wires on the throttle, attached the ends to the middle and righter-most...

no other throttles but i ordered the trimmer pot so we'll see how that works in a few days. thanks ....

thanks for that. i'll try the white wire limiter and see what that does. meanwhile, if possible, could you give me an amazon link to...

so, yes, the controllers are different, as is the LED. as to being cheap, could be but the package i linked to has been used...

nope, the controllers are different. i'm going to go outside and look at a few things ....

here's the correct link. if you'd have a look at it, i'd be much obliged led and controller

it's a bafang motor, one of the so-called jump ones, connected to this: 24V/36V 350W 6MOSFET ebike Electric Bicycle Brushless Motor...

i replaced the motor on my ebike -- it had bad halls -- with an identical motor, along w/ a new controller. has the same battery. but...