Search results

Date Relevance Most replies

  1. P

    LiFePO4 48V 10Ah Battery pack with 20A BMS - no charging plug

    Hi Ebike gurus i have a 48V LiFePO4 battery pack with a 20 Amp BMS which has only one XT60 plug ( +ve red wire and - ve black wire ) for powering the Controller and charging purposes. i need to disconnect the XT60 plug from the Controller and than connect it to my Battery charger (5...
  2. P

    Cycle Analyst v3.1 & 9C hub motor trouble shooting

    Hi my problem has been solved with the help from GRIN TECHNOLOGIES internal technical support. the solution: -the Crystalyte Controller no. 6 plug ( 6 pin female CycleAnalyst CA ) to the Cycle Analyst V3.1 plug ( 6 pin male ). -the Thumb Throttle plug ( 3 pin male ) to the Crystalyte...
  3. P

    Cycle Analyst v3.1 & 9C hub motor trouble shooting

    excuse my error... So what specifically happens when you set the CA to Bypass mode in the Throttle menu? in Bypass mode nothing happens ie; hub motor won't spin when thumb throttle is turned but the CA Slider bar goes up & down on the main display in response to the thumb throttle being...
  4. P

    Cycle Analyst v3.1 & 9C hub motor trouble shooting

    yup...no luck gone through all the Cycle Analyst CA setups could be a defective CA without the CA disconnected, hub motor runs well.
  5. P

    Cycle Analyst v3.1 & 9C hub motor trouble shooting

    ebike gurus i have the following hardware all connected up but hub motor will not spin or work when power is ON & the Thumb throttle is turned. the THROTTLE SLIDER on the Cycle Analyst main display can be seen moving up & down when the Thumb throttle is turned to max & min. it seems the...
Back
Top