Bafang MAX drive (250W) readout

[maz0n1]

I tried that cable "hiekkis" mentioned to connect thumb throttle to max drive. No dice. Connector is different to controllers end.
Next i will try bafang ultra drive eb-bus cable.
I have a 48v version max drive 350w with 17A controller. Runs great 100% keep current ja current decay 8.
Fat bike frame slowers down top speeds, but tops out at ~42km/h with clown pedalin on flat

 

[dannyb0uy]

Any luck with the thumb throttle?

 

[brikmange]

Hi! New here, and been reading this thread a lot. I've got an Evobike mid engine 8 geared bike. Thinking about maybe reprogramming my 250w engine to make it 350w. Anyone got readouts of factory setting for a 36v 350W max drive? @Elenhinan, where did you find info about that the sw06 controller is good for 350w?

Well, first I need to check if I can access the connection port easily, and then find a programming cable. If so, let's see.

 

[Bikegirl]

Great info guys,
It ha got me thinking, would it be possible to over volt my mm G330. 350 from 48v to 52v?

Or would it be worth changing controller to do that?

 

[Rosse]

Where do i download this tool/software?