I am at my wits end trying to find out the best way to lay this battery pack out. I have read so many instructions and looked at a lot of photos with no clear way of laying it out. I am trying to make a 52v 20 AH pack with 91 cells using a polly PD-9 Box. the cells are recovered from backup packs with minimal use. the specs are:
Model: LGABF1L1865 (INR18650F1L)
Capacity: 3350mAh Rated
Voltage: 3.63V Nominal
Charging: 4.20V Maximum 975mA Standard 1625mA Maximum
The bike motor is an Janopay 1,000WAH 48v-52v I have attached a layout that I put into my battery layout not sure its correct or how to connect what to what.the battery holder is a Polly DP-9 Down Tube max load of 91
If anyone could help me with the layout I would appreciate it I'm beginning to think I just should have bought an off the shelf Pack. I would like to just do the pulling of the nickel strips only once. If more info is needed just let me know.
Thank you
Model: LGABF1L1865 (INR18650F1L)
Capacity: 3350mAh Rated
Voltage: 3.63V Nominal
Charging: 4.20V Maximum 975mA Standard 1625mA Maximum
The bike motor is an Janopay 1,000WAH 48v-52v I have attached a layout that I put into my battery layout not sure its correct or how to connect what to what.the battery holder is a Polly DP-9 Down Tube max load of 91
If anyone could help me with the layout I would appreciate it I'm beginning to think I just should have bought an off the shelf Pack. I would like to just do the pulling of the nickel strips only once. If more info is needed just let me know.
Thank you