controller for PMSM wiring help

[Hammer247]

can someone PLEASE help me or point me in the right direction??

i bought an electric motorcycle about 1 1/2yrs ago. i used it a couple times and i never got it going again (dont remember why). i used some parts off it and last summer, i ripped the wiring out. both the controller and harness have been altered.

i'm looking for a wiring diagram so i can hook it up (properly, i hope).

i know the motor/hall sensor/phase/battery wires

im pretty sure the CUT red and black wires were for the charging port.

the red connector (orange/blue/green) was maybe connected to an alarm?

blue/black/yellow wire connector?

13-pin connector?

 

[pwd]

Not likely you will find a diagram specific to that bike + controller but you can try searching the model number Verify everything with a multimeter. In general a hall based throttle will require +5VDC and 0V/ground and output the throttle signal with the third pin.