Cyclone motor

[mafire@email.c]

Hello

 

[DingusMcGee]

1st. Contact eclipse bikes and ask them for help.

 

[mafire@email.c]

i did it - no answer yet.

 

[mafire@email.c]

please ?

 

[minimum]

If your hall sensors supply measures battery voltage instead of 5VDC then your problem is likely worse - damaged controller aside hall sensors.

 

[Voltron]

I'm not sure with the Cyclone, does it have an internal clutch or an external freewheel? If it's internal, that would explain the sound but no output. If you put your hand on it when you turn the throttle does it vibrate like the motor is spinning inside?

 

[mafire@email.c]

It have external freewheel.

 

[zackclark70]

i can help with this ( as far as i know i am the only person to have done a full rewind on one of these motors and one of a handfull that has fully striped one of these )

If your having coging issues like the video that does suggest hall sensor problems have you taken the gearbox and top plate of the motor yet ?
btw the pin out for the hall wires is as follows
purp / blue temp cutout ( just a loop of the power switch wire really )
orange is ground
yellow is +5v or +15v depending on controller
black is hw
white is hv
red is hu
( with the controller on the voltage of hw hv and hu will go between +0v and +5-6v as you rotate the motor slowly )

also unplug all motor connectors and measure the resistance between the motor case and each of the 3 phase wires if they have low resistance there is a short ( can still be fixed just harder )

i am more than happy to help you or anyone that has one of these motors just give me a message

no mater what the problem is it can be fixed i will pm my phone number feel free to whatsapp call me any time ( i am in the uk )

 

[sather]

Robocam posted instructions and photos on how to do it

https://endless-sphere.com/forums/viewtopic.php?f=28&t=69867&p=1283830&hilit=hall#p1283830

Quote: "If you email Paco, he'll probably give them to you for free (plus shipping). He did for me.

viewtopic.php?f=28&t=69867&p=1224666#p1224666

viewtopic.php?f=28&t=69867&hilit=radiator&start=1275#p1209434

viewtopic.php?f=28&t=69867&hilit=radiator&start=1350#p1223294"

 

[zackclark70]

Robocam posted instructions and photos on how to do it

https://endless-sphere.com/forums/viewtopic.php?f=28&t=69867&p=1283830&hilit=hall#p1283830

Quote: "If you email Paco, he'll probably give them to you for free (plus shipping). He did for me.

viewtopic.php?f=28&t=69867&p=1224666#p1224666

viewtopic.php?f=28&t=69867&hilit=radiator&start=1275#p1209434

viewtopic.php?f=28&t=69867&hilit=radiator&start=1350#p1223294"

the 3 hall chips are only a few £ easy to swap out and wont take more than a few days to show up cyclone can take a month to get here