Glove remote

[higrade]

Could this be modded to work on a skateboard

https://www.youtube.com/watch?v=K_v29quCS-8

http://forceflyers.com/


I figure we don't need the gyro part but the formfactor is perfect

you can get the car from amazon with the remote for $32 only have one left but figure if you search there should be more, but would it be possible to take the brain out the car and put it on an esc

http://www.amazon.com/Force-Flyers-scale-Glove-Controlled/dp/B00CJJXTOY/ref=pd_rhf_eeolp_s_cp_2_1K4A?ie=UTF8&refRID=0P4A219ERVCE82JNY8Z4

 

[torqueboards]

I'm sure you could do it. I don't have the skills though.

The receiver is most likely built into the PCB of the toy though it's as a whole. Sometimes it's not though.

Interesting..

 

[Philosopher]

Pretty neat!

 

[SlowNinja]

This is similar to an idea I am tinkering with for my build. Basically just put Nyko Kama guts into a puck-shaped housing that can be stuck to standard longboard slide gloves. Build it symmetrical, and it can stick to left or right hand. No worrying about letting go of the remote. It would cost more for the initial investment because a decent glove is going to cost more than a nunchuck controller, but it would be even more discreet than a regular controller. The problem would be in ergonomics. The puck would have to be farther forward than on regular gloves.

 

[mccloed]

I built a glove remote. Just took a Quantum apart.

 

[higrade]

Is there anyone here with the technical ability to see if this would work, we can start a donation to get it to someone to look at it maybe the board is even separate and we would just have to solder some wires. The fact that they make a car and a plane would lead me to think they have it as a module.

If i were not in the middle of my build i would just buy it

This might be dumb but should it not be possible to get one of these

http://www.rcplanet.com/Radio_Receiver_FM_s/1227.htm

and program it to the frequency of the glove.