Got a build - 3d printed mounts & dual SK3 4250

[got92]

Hello everyone!

Finally i've complete my board, more or less XD, but it moves so the rough part is made.
I'm not so good at writing, and my english kinda sucks, soo .. less word and more facts

I wanted a light, small board to go to my uni, and around. After long time this is come up:





- 31" board
- fifty Caliber mount
- huge 90mm Abec-clones wheels
- twin Sk3 4250 410kv
- twin 90A Hobbyking Boat esc
- two 3s lipo 5000 mah
- wii nunchck as controller
- all controlled by an arduino nano
- 3d printed mounts and the big gear

For now i haven't tested completely out. But it rocks

What's missing?

-a case (of course XD), i have no idea how it will looks like

-a wattmeter, i would to mìdo that with the arduino a power-module like this (http://i.ebayimg.com/00/s/NjAwWDU5OQ==/z/ynAAAOxywh1TDEAy/$_12.JPG)
but the sd-log is not compatibile with the controller-code (i hav not idea how), so i have order another arduino :?

-led?

-maybe a better controller, sadly i've bought a nyko-kama wii controller and the code to control it sucks



Perfomance:

the gps said 116 km/h of average speed for 35 km .. maybe the gps has some problem XD.
However i have tested the maximal ampere consume and it's about 22Ah. So for 6s lipo is about 500wh



Hope you like it!
Good ideas are of course welcome

 

[bowlofsalad]

What material did you print the parts in? What can you tell us about your 3D printer? How thick are those mounts?

 

[got92]

What material did you print the parts in? What can you tell us about your 3D printer? How thick are those mounts?

I used abs for the print. My printer is a diy one, it's like this http://reprap.org/wiki/Prusa_i3.

The mounts is 9mm thick :wink:

 

[psychotiller]

I have a Nyko Kama and it works great with this : http://endless-sphere.com/forums/viewtopic.php?f=35&t=59582&start=200

 

[torqueboards]

Nice 3D Printed Mounts. Have you been riding it hard? I'm curious to know if it holds up to your riding on campus.

 

[psychotiller]

I like that swallow tail deck! Clean looking mounts too! Are you going to make them out of aluminum eventually?

 

[got92]

Nice 3D Printed Mounts. Have you been riding it hard? I'm curious to know if it holds up to your riding on campus.

Not yet. But seems pretty solid

I like that swallow tail deck! Clean looking mounts too! Are you going to make them out of aluminum eventually?

If I had access to the machine for sure! Aluminium looks a lot more professional than white plastic