Hi guys,
I´m trying to configurate my conttroler but I'm not geting there.
I have a Cromotor 2 and a 25S 9P Sony 18650 Batterie fully charge 102,5 V no BMS
I have already programmed the controller with this three profiles bellow, none of them work.
Two weeks ago I was trying to put the bike working and I was changing the face collors and the all sensor. After trying a few diferent modes the bike run for 50 meters.
After this situation I know now that all the wires are well connected. I think the bike runned for a few meters because the batteries are losing voltage on these last four months and they have reached the tension the controller is programmed to. As soon as I gave more trottle the tension dropped and the bike stopped and never work again.
I have charge the batteries to see if that will make the difference but nothing happened.
I´m trying to configurate my conttroler but I'm not geting there.
I have a Cromotor 2 and a 25S 9P Sony 18650 Batterie fully charge 102,5 V no BMS
I have already programmed the controller with this three profiles bellow, none of them work.
Two weeks ago I was trying to put the bike working and I was changing the face collors and the all sensor. After trying a few diferent modes the bike run for 50 meters.
After this situation I know now that all the wires are well connected. I think the bike runned for a few meters because the batteries are losing voltage on these last four months and they have reached the tension the controller is programmed to. As soon as I gave more trottle the tension dropped and the bike stopped and never work again.
I have charge the batteries to see if that will make the difference but nothing happened.